Siemens SINUMERIK Series Operating Manual page 147

In addition to the offset (course and fine), the associated rotation, scaling and mirroring are
also displayed.
This window is generally used only for monitoring.
Display of active work offsets
Work offsets
MCS actual value
Kin. trans. workpiece
Kin. trans. tool
DRF
$AA_OFF overlay
Basic reference
External WO frame
Total base WO
G500
Tool reference
Workpiece reference
Transformer reference
Programmed WO
Cycle reference
Total WO
T:
WCS actual value
The display of the zero point offsets depends on the settings.
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Display of the actual value in the Machine Coordinate Sys‐
tem.
Displays the additional work offsets programmed with
$P_TRAFRAME_P.
Displays the additional work offsets programmed with
$P_TRAFRAME_T.
Displays the handwheel axis offset.
Displays the overlaid movement programmed with
$AA_OFF.
Displays the additional work offsets programmed with
$P_SETFRAME.
Access to the system offsets is protected via a keyswitch.
Displays the additional work offsets programmed with
$P_EXTFRAME.
Displays all effective basis offsets.
Displays the work offsets activated with G54 - G599.
Under certain circumstances, you can change the data us‐
ing "Set WO", i.e. you can correct a zero point that has been
set.
Displays the additional work offsets programmed with
$P_TOOLFRAME.
Displays the additional work offsets programmed with
$P_WPFRAME.
Displays the additional work offsets programmed with
$P_TRAFRAME.
Displays the additional work offsets programmed with
$P_PFRAME.
Displays the additional work offsets programmed with
$P_CYCFRAME.
Displays the active work offset, resulting from the total of all
work offsets.
Displays the active tool.
Displays the actual value in the Workpiece Coordinate Sys‐
tem.
Setting up the machine
4.8 Zero offsets
147