Siemens SINUMERIK Series Operating Manual page 344

Creating a ShopMill program
9.14 Changing program settings
Parameters Description
∅A
ØI
● Centered cuboid
W
L
● Cuboid
X0
Y0
X1
Y1
ZA
ZI
● Polygon
N
SW
L
● Without
HA Initial dimension
HI Final dimension (abs) or final dimension in relation to HA (inc)
PL Machining plane
● G17 (XY)
● G18 (ZX)
● G19 (YZ)
RP Retraction plane (abs)
SC Safety clearance (inc)
Acts in relation to the reference point. The direction in which the safety clearance is effec‐
tive is automatically determined by the cycle.
Machining Milling direction
direction
● Down-cut
● Up-cut
Retraction position Lift mode before new infeed
pattern
● To RP
● Optimized
344
Outer diameter ∅
Inner diameter Ø (abs) or wall thickness (inc)
Width of blank
Length of blank
1st corner point X
1st corner point Y
2nd corner point X (abs) or 2nd corner point X referred to X0 (inc)
2nd corner point X (abs) or 2nd corner point X referred to X0 (inc)
Initial dimension
Final dimension (abs) or final dimension in relation to ZA (inc)
Number of edges
Width across flats
Edge length
No blank use
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
Milling