Siemens SINUMERIK Series Operating Manual page 808

Hide thumbs Also See for SINUMERIK Series:

Table of Contents

Managing programs

14.20 Multiple clamping

If you switch from the assignment list (without canceling) to another function and then call the

"Multiple clamping" function later, the same assignment list is displayed again.

The program is included in the assignment list.

Assigned ShopMill programs that are not in the folder in which you create

the multiple clamping program, are displayed with the complete path

Place the cursor on the desired program and press the "Delete selection"

softkey if you want to remove individual programs from the assignment

Press the "Delete all" softkey if you want to remove all programs from the

global program.

Press the "OK" softkey when the assignment list is complete.

This optimizes the tool changes.

The global program is then renumbered. The number of the current

clamping is specified every time the program switches from one clamping

Apart from the global program (XYZ.MPF), the file XYZ_MCD.INI is also

set up in which the assignment between work offsets and programs is

stored. Both programs are stored in the directory that was previously

selected in the Program Manager.

Operating Manual, 08/2018, 6FC5398-7CP41-0BA0