Siemens SINUMERIK Series Operating Manual page 451

Parameters in the "Input complete" mode
G code program parameters
Input
PL Machining plane
Milling direction
RP Retraction plane
SC Safety clearance
F Feedrate
Parameter Description
Reference point Position of the reference point:
● (lefthand edge)
● (inside left)
● (center)
● (inside right)
● (righthand edge)
Machining
● ∇ (roughing)
● ∇∇∇ (finishing)
● ∇∇∇ edge (edge finishing)
● Chamfering
Machining posi‐
● Single position
tion
A slot is milled at the programmed position (X0, Y0, Z0).
● Position pattern
Several slots are milled at the programmed position pattern (e.g. pitch circle, grid,
line).
The positions refer to the reference point:
X0 Reference point X – (only for single position)
Y0 Reference point Y – (only for single position)
Z0 Reference point Z – (only for single position and G code position pattern)
W Slot width
L Slot length
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
ShopMill program parameters
● complete
T
D
mm F
mm S / V
*
Programming technological functions (cycles)
Tool name
Cutting edge number
Feedrate
Spindle speed or constant cutting
rate
10.2 Milling
mm/min
mm/tooth
rpm
m/min
Unit
mm
mm
mm
mm
mm
451