Siemens SINUMERIK Series Operating Manual page 649

Hide thumbs Also See for SINUMERIK Series:

Table of Contents

For CAM programs in the HSC range, the four machining types directly relate to the accuracy

and speed of the path contour (see help screen).

The operator/programmer uses the tolerance value to give a corresponding weighting.

Corresponding to the appropriate G commands, the four machining types are assigned to

technology G group 59:

Machining type

Rough-finishing

In the "Machine" operating area, the G functions that are active in the part program are shown

in the "G functions" window.

Orientation tolerance

You can enter the orientation tolerance for applications on machines with the dynamic multi-

axis orientation transformation (TRAORI).

Additional G commands that are available for use in machining free-form surfaces, are also

activated in the High Speed Settings cycle.

When deselecting CYCLE832, the G groups are programmed to the settings - during the

program run time - that are declared in the machine data for the reset state.

For additional information, please refer to the following documentation:

SINUMERIK Operate Commissioning Manual

Programming Manual, Job Planning

Operating Manual, 08/2018, 6FC5398-7CP41-0BA0

Technology G group 59

The part program or ShopMill program to be processed has been created

and you are in the editor.

Press the "Various" softkey.

Press the "High Speed Settings" softkey.

The "High Speed Settings" input window is opened.

Press the "Default values" softkey if you want to store default values for

axis tolerance values depending on the machining.

Programming technological functions (cycles)

10.6 Further cycles and functions