Siemens SINUMERIK Series Operating Manual page 467

Parameter Description
The positions refer to the reference point:
X0 Reference point X – (for single position only)
Y0 Reference point Y – (for single position only)
Z0 Reference point Z – (single position only and G Code position pattern)
W Slot width
L Slot length
α0 Angle of rotation of slot
Z1 Slot depth (abs) or depth relative to Z0 (abs) – (only for ∇, ∇∇∇, ∇∇∇ base and ∇∇∇ rough
finishing)
DXY ● Maximum plane infeed
● Maximum plane infeed as a percentage of the milling cutter diameter
- (only for ∇)
DZ Maximum depth infeed - (only for ∇, ∇∇∇ rough finishing, ∇∇∇ and ∇∇∇ edge)
- (only for vortex milling)
UXY Plane finishing allowance (slot edge) - (only for ∇, ∇∇∇ rough finishing and ∇∇∇ base)
UZ Depth finishing allowance (slot base) - (only for ∇, ∇∇∇ rough finishing and ∇∇∇ edge )
FS Chamfer width for chamfering (inc) - (for chamfering only)
ZFS Insertion depth of tool tip (abs or inc) - (for chamfering only)
* Unit of feedrate as programmed before the cycle call
Parameters in the "Input simple" mode
G code program parameters
Input
Milling direction
RP Retraction plane
F Feedrate
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
● simple
mm
*
Programming technological functions (cycles)
ShopMill program parameters
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant
cutting rate
10.2 Milling
Unit
mm
mm
mm
mm
mm
Degrees
mm
mm
%
mm
mm
mm
mm
mm
mm/min
mm/rev
rpm
m/min
467