Siemens SINUMERIK Series Operating Manual page 497

Hide thumbs Also See for SINUMERIK Series:

Table of Contents

5. Predrill (this is only possible for pocket contour)

6. Solid machine/machine pocket / spigot - roughing

7. Solid machine/machine remaining material - roughing

8. Finishing (base/edge)

9. Chamfering

The following error messages can occur when chamfering inside contours:

Safety clearance in the program header too large

This error message appears when chamfering would, in principle, be possible with the

parameters entered for FS and ZFS, but the safety clearance then could not be maintained.

Immersion depth too large

This error message appears when chamfering would be possible through the reduction of

the immersion depth ZFS.

Tool diameter too large

This error message appears when the tool would already damage the edges during

insertion. In this case, the chamfer FS must be reduced.

Name convention

For multi-channel systems, cycles attach a "_C" and a two-digit number of the specific channel

to the names of the programs to be generated, e.g. for channel 1 "_C01". This is the reason

that the name of the main program must not end with "_C" and a two-digit number. This is

monitored by the cycles.

For single-channel systems, cycles do not extend the name of the programs to be generated.

G code programs

For G code programs, the programs to be generated, which do not include any path data, are

saved in the directory in which the main program is located. In this case, it must be ensured

that programs, which already exist in the directory and which have the same name as the

programs to be generated, are overwritten.

Operating Manual, 08/2018, 6FC5398-7CP41-0BA0

Software option

For solid machining residual material, you require the option "residual material

detection and machining".

Programming technological functions (cycles)

10.3 Contour milling