Siemens SINUMERIK Series Operating Manual page 612

Programming technological functions (cycles)
10.5 Contour turning - Milling/turning machine
Parameter Description
BL Blank description (only for ∇)
● Cylinder (described using XD, ZD)
● Allowance (XD and ZD on the finished part contour)
● Contour (additional CYCLE62 call with blank contour – e.g. cast iron mold)
XD - (only for ∇ machining)
- (only for blank description, cylinder and allowance)
● For blank description, cylinder
● For blank description, allowance
ZD - (only for ∇ machining)
- (only for blank description, cylinder and allowance)
● For blank description, cylinder
● For blank description, allowance
Allowance Allowance for pre-finishing - (only for ∇∇∇)
● Yes
● No
U1 Compensation allowance in X and Z direction (inc) – (only for allowance)
● Positive value: Compensation allowance is kept
● Negative value: Compensation allowance is removed in addition to finishing
* Unit of feedrate as programmed before the cycle call
Hidden parameters
The following parameters are hidden. They are pre-assigned fixed values or values that can
be adjusted using setting data.
Parameter Description
Residual material Without subsequent residual material removal
PL Machining plane
SC Safety clearance
DI Continuous cut - (only for ∇)
612
– Version, absolute:
Cylinder dimension ∅ (abs)
– Version incremental:
Allowance (inc) to maximum values of the CYCLE62 finished part contour
– Allowance on the CYCLE62 finished part contour (inc)
– Version, absolute:
Cylinder dimension (abs)
– Version incremental:
Allowance (inc) to maximum values of the CYCLE62 finished part contour
– Allowance on the CYCLE62 finished part contour (inc)
U1 contour allowance
allowance
Value Can be set in SD
No
Defined in MD
52005
0
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Unit
mm
mm
mm
mm
x
Milling