Siemens SINUMERIK Series Operating Manual page 629

Parameter Description
C1 The required angle can be freely entered.
(for ShopMill pro‐
gram)
αC Rotational position for a pole position.
(for ShopMill pro‐
gram)
Hirth joint
● Round to the next Hirth joint
● Round up to Hirth joint
● Round down to Hirth joint
Note:
For machines with a Hirth joint
Tool Tool tip when swiveling
● Tracking
The position of the tool tip is maintained during swiveling.
● No tracking
The position of the tool tip is not maintained during swiveling.
Preferred direction Preferred direction of the swivel axis for several possible alignments of the machine.
(for ShopMill pro‐
gram)
FX Feedrate in X direction
FZ Feedrate in Z direction
Machining
● ∇ (roughing)
● ∇∇∇ (finishing)
Machining
● Face
direction
● Longitudinal
Position ● Front
● Rear
● Inside
● Outside
D Maximum depth infeed - (only for ∇)
UX or U Finishing allowance in X or finishing allowance in X and Z – (only for ∇)
UZ Finishing allowance in Z – (only for UX)
XDA First grooving limit tool ∅ (abs) – (end face or rear face only)
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Programming technological functions (cycles)
10.5 Contour turning - Milling/turning machine
Unit
Degrees
Degrees
*
*
mm
mm
mm
mm
629