Contour Call (Cycle62) - Siemens SINUMERIK Series Operating Manual

10.5.6

Contour call (CYCLE62)

Function
The input creates a reference to the selected contour.
There are four ways to call the contour:
1. Contour name
The contour is in the calling main program.
2. Labels
The contour is in the calling main program and is limited by the labels that have been
entered.
3. Subprogram
The contour is located in a subprogram in the same workpiece.
4. Labels in the subprogram
The contour is in a subprogram and is limited by the labels that have been entered.
Procedure
Parameter
Contour selection
Contour name
Labels
Subprogram
Labels in the subpro‐
gram
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
1. The part program to be executed has been created and you are in the
editor.
2. Press the "Turning" and "Contour turning" softkeys.
3. Press the "Contour" and "Contour call" softkeys.
The "Contour Call" input window opens.
4. Assign parameters to the contour selection.
Description
● Contour name
● Labels
● Subprogram
● Labels in the subprogram
CON: Contour name
● LAB1: Label 1
● LAB2: Label 2
PRG: Subprogram
● PRG: Subprogram
● LAB1: Label 1
● LAB2: Label 2
Programming technological functions (cycles)
10.5 Contour turning - Milling/turning machine
Unit
585