Plunge Turning Residual Material (Cycle952) - Siemens SINUMERIK Series Operating Manual

10.5.12

Plunge turning residual material (CYCLE952)

Function
The "Plunge turning residual material" function is used when you want to machine the material
that remained after plunge turning.
For a G code program, select the function in the screen. Material that remains as part of the
finishing allowance is not residual material. The "Plunge turning residual material" function
allows you to remove unwanted material with a suitable tool.
The "Plunge turning residual material" function is a software option.
Procedure
G code program parameters
PRG Name of the program to be gener‐
ated
PL Machining
plane
RP Retraction
plane – (only for
machining di‐
rection, longitu‐
dinal, inner)
SC Safety clear‐
ance
Residual mate‐ With subsequent residual materi‐
rial al removal.
● Yes
● No
CONR Name to save the updated unma‐
chined-part contour for residual
material removal - (only "Yes" for
residual material removal).
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
1. The part program to be executed has been created and you are in the
editor.
2. Press the "Turning" and "Contour turning" softkeys.
3. Press the "Plunge turning residual material" softkey.
The "Plunge turning residual material" input window opens.
mm
mm
Programming technological functions (cycles)
10.5 Contour turning - Milling/turning machine
ShopMill program parameters
T Tool name
D Cutting edge
number
S / V Spindle speed
or
constant cut‐
ting rate
rpm
m/min
627