Installation And Commissioning; Introduction - ABB IRB 2400/L Product Manual

2 Installation and commissioning

2.1 Introduction

General
This chapter contains assembly instructions and information for installing the IRB
2400 at the working site.
More detailed technical data can be found in the Product specification for the IRB
2400, such as:
Safety information
Before any installation work is commenced, it is extremely important that all safety
information is observed.
There are general safety aspects that must be read through, as well as more specific
safety information that describes the danger and safety risks when performing the
procedures. Read the chapter
work.
Product manual - IRB 2400
3HAC022031-001 Revision: P
• Load diagram
• Permitted extra loads (equipment), if any
• Location of extra loads (equipment), if any.
Note
If the IRB 2400 is connected to power, always make sure that the robot is
connected to protective earth before starting any installation work.
For more information see:
• Product manual - IRC5
© Copyright 2004-2018 ABB. All rights reserved.
2 Installation and commissioning
Safety on page 19 before performing any installation
2.1 Introduction
49