ABB IRB 2400/L Product Manual page 114

4 Repair
4.2.2 Mounting instructions for bearings
Continued
The bearings must be greased after assembly according to the following
instructions:
Grease the different types of bearings as following description:
114
• The bearings must not be completely filled with grease. However, if space
is available beside the bearing fitting, the bearing may be totally filled with
grease when mounted, as excessive grease will be pressed out from the
bearing when the robot is started.
• During operation, the bearing should be filled to 70-80% of the available
volume.
• Ensure that grease is handled and stored properly to avoid contamination.
• Grooved ball bearings must be filled with grease from both sides.
• Tapered roller bearings and axial needle bearings must be greased in the
split condition.
© Copyright 2004-2018 ABB. All rights reserved.
Product manual - IRB 2400
3HAC022031-001 Revision: P