Mtest:load - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

7
Obsolete and Discontinued Commands

:MTESt:LOAD

Command Syntax
:MTESt:LOAD "<filename>"
The :MTESt:LOAD command loads the specified mask file.
The <filename> parameter is an MS- DOS compatible name of the file, a
maximum of 254 characters long (including the path name, if used).
The :MTESt:LOAD command is obsolete and is provided for backward compatibility to
N O T E
previous oscilloscopes. Use the :RECall:MASK[:STARt] command (see
See Also
•
•
602
(see page 658)
"Introduction to :MTESt Commands"
":MTESt:AMASk:{SAVE | STORe}"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 320
on page 599
page 354) instead.