Agilent Technologies InfiniiVision 5000 Series Programmer's Manual page 684

12
Programming Examples
}
/*
* capture
* ------------------------------------------------------------------
* This function prepares the scope for data acquisition and then
* uses the DIGITIZE MACRO to capture some data.
*/
void capture (void)
{
}
684
iprintf(id, ":RUN\n");
iprintf(id, ":STOP\n");
/* VIEW_BLANK (not executed in this example):
* - VIEW turns on (starts displaying) an active channel or pixel
* memory.
* - BLANK turns off (stops displaying) a specified channel or
* pixel memory.
*/
iprintf(id, ":BLANK CHANNEL1\n");
iprintf(id, ":VIEW CHANNEL1\n");
/* TIME_MODE (not executed in this example) - Set the time base
* mode to MAIN, DELAYED, XY or ROLL.
*/
iprintf(id, ":TIMEBASE:MODE MAIN\n");
/* AQUIRE_TYPE - Sets the acquisition mode.
* acquisition types NORMAL, PEAK, or AVERAGE.
*/
iprintf(id, ":ACQUIRE:TYPE NORMAL\n");
/* AQUIRE_COMPLETE - Specifies the minimum completion criteria
* for an acquisition.
* of time buckets needed to be "full" before an acquisition is
* considered to be complete.
*/
iprintf(id, ":ACQUIRE:COMPLETE 100\n");
/* DIGITIZE - Used to acquire the waveform data for transfer over
* the interface. Sending this command causes an acquisition to
* take place with the resulting data being placed in the buffer.
*/
/* NOTE! The use of the DIGITIZE command is highly recommended
* as it will ensure that sufficient data is available for
* measurement. Keep in mind when the oscilloscope is running,
* communication with the computer interrupts data acquisition.
* Setting up the oscilloscope over the bus causes the data
* buffers to be cleared and internal hardware to be reconfigured.
* If a measurement is immediately requested there may not have
* been enough time for the data acquisition process to collect
* data and the results may not be accurate.
* 9.9E+37 may be returned over the bus in this situation.
*/
iprintf(id, ":DIGITIZE CHAN1\n");
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
The parameter determines the percentage
There are three
An error value of