Agilent Technologies InfiniiVision 5000 Series Programmer's Manual page 566

7
Obsolete and Discontinued Commands
Obsolete Command
:PRINt? (see
:TIMebase:DELay (see
page
:TRIGger:CAN:ACKNowledge
(see
:TRIGger:CAN:SIGNal:DEFiniti
on (see
:TRIGger:LIN:SIGNal:DEFinitio
n (see
:TRIGger:TV:TVMode (see
page
Discontinued Discontinued commands are commands that were used by previous
Commands
oscilloscopes, but are not supported by the InfiniiVision 5000 Series
oscilloscopes. Listed below are the Discontinued commands and the
nearest equivalent command available (if any).
Discontinued Command
ASTore
CHANnel:MATH
CHANnel<n>:PROTect
DISPlay:INVerse
DISPlay:COLumn
DISPlay:GRID
DISPLay:LINE
DISPlay:PIXel
DISPlay:POSition
566
page 607)
609)
page 610)
page 611)
page 612)
613)
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
Current Command Equivalent
:DISPlay:DATA? (see
page 211)
:TIMebase:POSition (see
page 403) or
:TIMebase:WINDow:POSition
(see page 408)
none
none
none
:TRIGger:TV:MODE (see
page 481)
Current Command Equivalent
:DISPlay:PERSistence INFinite
(see page 215)
:FUNCtion:OPERation (see
page 237)
:CHANnel<n>:PROTection
(see page 203)
none
none
none
none
none
none
Behavior Differences
TIMebase:POSition is position
value of main time base;
TIMebase:WINDow:POSition
is position value of zoomed
(delayed) time base window.
Comments
ADD not included
Previous form of this
command was used to
enable/disable 50Ω
protection. The new command
resets a tripped protect and
the query returns the status of
TRIPed or NORMal.