:WAVeform:SOURce:SUBSource
Command Syntax
:WAVeform:SOURce:SUBSource <subsource>
<subsource> ::= {{NONE | RX} | TX}
If the :WAVeform:SOURce is SBUS (serial decode), more than one data set
may be available, and this command lets you choose from the available
data sets.
Currently, only UART serial decode lets you get "TX" data. The default,
NONE, specifies "RX" data. (RX is an alias for NONE.)
If the :WAVeform:SOURce is not SBUS, or the :SBUS:MODE is not UART,
the only valid subsource is NONE.
Query Syntax
:WAVeform:SOURce:SUBSource?
The :WAVeform:SOURce:SUBSource? query returns the current waveform
subsource setting.
Return Format
<subsource><NL>
<subsource> ::= {NONE | TX}
See Also
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see
page
658)
"Introduction to :WAVeform Commands"
":WAVeform:SOURce"
on page 502
on page 521
Commands by Subsystem
5
525