Trigger Commands - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:TRIGger Commands

Control the trigger modes and parameters for each trigger type. See:
•
•
•
•
•
•
•
•
•
•
•
Introduction to The commands in the TRIGger subsystem define the conditions for an
:TRIGger
internal trigger. Many of these commands are valid in multiple trigger
Commands modes.
The default trigger mode is :EDGE.
The trigger subsystem controls the trigger sweep mode and the trigger
specification. The trigger sweep (see
be AUTO or NORMal.
• NORMal mode displays a waveform only if a trigger signal is present
• AUTO trigger mode generates an artificial trigger event if the trigger
The following trigger types are available (see
page 417).
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
"Introduction to :TRIGger Commands"
"General :TRIGger Commands"
":TRIGger:CAN Commands"
":TRIGger:DURation Commands"
":TRIGger[:EDGE] Commands"
":TRIGger:GLITch Commands"
":TRIGger:IIC Commands"
":TRIGger:LIN Commands"
":TRIGger:SPI Commands"
":TRIGger:TV Commands"
":TRIGger:UART Commands"
and the trigger conditions are met. Otherwise the oscilloscope does not
trigger and the display is not updated. This mode is useful for
low- repetitive- rate signals.
specification is not satisfied within a preset time, acquires
unsynchronized data and displays it.
AUTO mode is useful for signals other than low- repetitive- rate signals.
You must use this mode to display a DC signal because there are no
edges on which to trigger.
on page 411
on page 414
on page 422
on page 433
on page 439
on page 445 (Pulse Width trigger)
on page 453
on page 462
on page 470
on page 479
on page 485
":TRIGger:SWEep"
":TRIGger:MODE"
Commands by Subsystem
on page 421) can
on
5
411