Trigger:uart:parity - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:TRIGger:UART:PARity

Command Syntax
:TRIGger:UART:PARity <parity>
<parity> ::= {EVEN | ODD | NONE}
The :TRIGger:UART:PARity command selects the parity to be used with
each message "byte" for the serial decoder and/or trigger when in UART
mode.
Query Syntax
:TRIGger:UART:PARity?
The :TRIGger:UART:PARity? query returns the current UART parity setting.
Return Format
<parity><NL>
<parity> ::= {EVEN | ODD | NONE}
See Also
•
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 658)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 417
":TRIGger:UART:TYPE"
on page 411
on page 498
Commands by Subsystem
5
493