5
Commands by Subsystem
Vtop. If you want to move the delay measurement point nearer to Vtop or
Vbase, you must change the threshold values with the :MEASure:DEFine
THResholds command.
Return Format
<value><NL>
<value> ::= floating-point number delay time in seconds in NR3 format
See Also
•
•
•
280
"Introduction to :MEASure Commands"
":MEASure:DEFine"
on page 276
":MEASure:PHASe"
on page 288
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 272