:MARKer:X1Position
Command Syntax
:MARKer:X1Position <position> [suffix]
<suffix> ::= {s | ms | us | ns | ps | Hz | kHz | MHz}
The :MARKer:X1Position command:
• Sets :MARKer:MODE to MANual if it is not currently set to WAVeform
• Sets the X1 cursor position to the specified value.
Query Syntax
The :MARKer:X1Position? query returns the current X1 cursor position.
This is functionally equivalent to the obsolete :MEASure:TSTArt
command/query.
If the front-panel cursors are off, the marker position values are not defined and an error is
N O T E
generated. Make sure to set :MARKer:MODE to MANual or WAVeform to put the cursors in
<position> ::= X1 cursor position in NR3 format
•
•
•
•
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see
page
658)
(see
on page 258
":MEASure:TSTArt"
on page 591
on page 257
on page 261
on page 260
on page 262
Commands by Subsystem
5
259