Sbus:uart:count:reset - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:SBUS:UART:COUNt:RESet

Command Syntax
:SBUS:UART:COUNt:RESet
Resets the UART frame counters.
This command is only valid on 4 (analog) channel oscilloscope models when the
N O T E
UART/RS-232 triggering and serial decode option (Option 232) has been licensed.
Errors •
See Also •
•
•
•
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 658)
"- 241, Hardware missing"
":SBUS:UART:COUNt:ERRor"
":SBUS:UART:COUNt:RXFRames"
":SBUS:UART:COUNt:TXFRames"
"Introduction to :SBUS Commands"
":SBUS:MODE" on page 383
":TRIGger:UART Commands"
on page 617
on page 386
on page 388
on page 389
on page 374
on page 485
Commands by Subsystem
5
387