Agilent Technologies InfiniiVision 5000 Series Programmer's Manual page 733

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
oscp.DoCommand("*CLS")
' IDN - Ask for the device's *IDN string.
strResults = oscp.DoQueryString("*IDN?")
' Display results.
Console.Write("Result is: {0}", strResults)
' AUTOSCALE - This command evaluates all the input signals
' and sets the correct conditions to display all of the
' active signals.
oscp.DoCommand(":AUToscale")
' CHANNEL_PROBE - Sets the probe attenuation factor for the
' selected channel.
' 0.1 to 1000.
oscp.DoCommand(":CHANnel1:PROBe 10")
' CHANNEL_RANGE - Sets the full scale vertical range in volts.
' The range value is eight times the volts per division.
oscp.DoCommand(":CHANnel1:RANGe 8")
' TIME_RANGE - Sets the full scale horizontal time in seconds.
' The range value is ten times the time per division.
oscp.DoCommand(":TIMebase:RANGe 2e-3")
' TIME_REFERENCE - Possible values are LEFT and CENTER:
' - LEFT sets the display reference one time division from
' the left.
' - CENTER sets the display reference to the center of the
' screen.
oscp.DoCommand(":TIMebase:REFerence CENTer")
' TRIGGER_SOURCE - Selects the channel that actually produces
' the TV trigger.
oscp.DoCommand(":TRIGger:TV:SOURCe CHANnel1")
' TRIGGER_MODE - Set the trigger mode to, EDGE, GLITch,
' PATTern, CAN, DURation, IIC, LIN, SEQuence, SPI, TV,
' UART, or USB.
oscp.DoCommand(":TRIGger:MODE EDGE")
' TRIGGER_EDGE_SLOPE - Set the slope of the edge for the
' trigger to either POSITIVE or NEGATIVE.
oscp.DoCommand(":TRIGger:EDGE:SLOPe POSitive")
End Sub
' Extra()
' --------------------------------------------------------------
' The commands in this function are not executed and are shown
' for reference purposes only.
' this function from main.
Private Shared Sub Extra()
' RUN_STOP (not executed in this example):
The probe attenuation factor may be from
Any channel can be selected.
To execute these commands, call
Programming Examples
733
12