Agilent Technologies InfiniiVision 5000 Series Programmer's Manual page 757

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
* for reference purposes only.
* this function from main.
*/
private static void Extra()
{
/* RUN_STOP (not executed in this example):
* - RUN starts the acquisition of data for the active
* waveform display.
* - STOP stops the data acquisition and turns off AUTOSTORE.
*/
myScope.DoCommand(":RUN");
myScope.DoCommand(":STOP");
/* VIEW_BLANK (not executed in this example):
* - VIEW turns on (starts displaying) an active channel or
* pixel memory.
* - BLANK turns off (stops displaying) a specified channel or
* pixel memory.
*/
myScope.DoCommand(":BLANk CHANnel1");
myScope.DoCommand(":VIEW CHANnel1");
/* TIME_MODE (not executed in this example) - Set the time base
* mode to MAIN, DELAYED, XY or ROLL.
*/
myScope.DoCommand(":TIMebase:MODE MAIN");
}
/*
* Capture()
* --------------------------------------------------------------
* This function prepares the scope for data acquisition and then
* uses the DIGITIZE MACRO to capture some data.
*/
private static void Capture()
{
/* AQUIRE_TYPE - Sets the acquisition mode.
* acquisition types NORMAL, PEAK, or AVERAGE.
*/
myScope.DoCommand(":ACQuire:TYPE NORMal");
/* AQUIRE_COMPLETE - Specifies the minimum completion criteria
* for an acquisition.
* of time buckets needed to be "full" before an acquisition is
* considered to be complete.
*/
myScope.DoCommand(":ACQuire:COMPlete 100");
/* DIGITIZE - Used to acquire the waveform data for transfer
* over the interface.
* acquisition to take place with the resulting data being
* placed in the buffer.
*/
/* NOTE! The use of the DIGITIZE command is highly recommended
* as it will ensure that sufficient data is available for
* measurement. Keep in mind when the oscilloscope is running,
To execute these commands, call
The parameter determines the percentage
Sending this command causes an
Programming Examples
There are three
757
12