Sbus:uart:framing - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

5
Commands by Subsystem

:SBUS:UART:FRAMing

Command Syntax
:SBUS:UART:FRAMing <value>
<value> ::= {OFF | <decimal> | <nondecimal>}
<decimal> ::= 8-bit integer in decimal from 0-255 (0x00-0xff)
<nondecimal> ::= #Hnn where n ::= {0,..,9 | A,..,F} for hexadecimal
<nondecimal> ::= #Bnn...n where n ::= {0 | 1} for binary
The :SBUS:UART:FRAMing command determines the byte value to use for
framing (end of packet) or to turn off framing for UART decode.
This command is only valid on 4 (analog) channel oscilloscope models when the
N O T E
UART/RS-232 triggering and serial decode option (Option 232) has been licensed.
Query Syntax
:SBUS:UART:FRAMing?
The :SBUS:UART:FRAMing? query returns the current UART decode base
setting.
Return Format
<value><NL>
<value> ::= {OFF | <decimal>}
<decimal> ::= 8-bit integer in decimal from 0-255
Errors •
See Also •
•
390
(see page 658)
"- 241, Hardware missing"
"Introduction to :SBUS Commands"
":TRIGger:UART Commands"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 617
on page 374
on page 485