Agilent Technologies InfiniiVision 5000 Series Programmer's Manual page 148

5
Commands by Subsystem
Table 41 Operation Status Condition Register (continued)
Bit
3
2-0
Return Format
<value><NL>
<value> ::= integer in NR1 format.
See Also
•
•
•
•
•
•
•
•
•
•
•
•
•
148
Name Description
Run Running
--- ---
"Introduction to Root (:) Commands"
":CHANnel<n>:PROTection"
":EXTernal:PROTection"
":OPEE (Operation Status Enable Register)"
":OPERegister[:EVENt] (Operation Status Event Register)"
":OVLenable (Overload Event Enable Register)"
":OVLRegister (Overload Event Register)"
"*STB (Read Status Byte)"
"*SRE (Service Request Enable)"
":HWERegister[:EVENt] (Hardware Event Event Register)"
":HWEenable (Hardware Event Enable Register)"
":MTERegister[:EVENt] (Mask Test Event Event Register)"
":MTEenable (Mask Test Event Enable Register)"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
When Set (1 = High = True), Indicates:
The oscilloscope is running (not stopped).
(Not used.)
on page 124
on page 203
on page 225
on page 153
on page 117
on page 115
on page 145
on page 149
on page 151
on page 138
on page 134
on page 143
on page 141