Agilent Technologies InfiniiVision 5000 Series Programmer's Manual page 374

5
Commands by Subsystem
Table 57 :SBUS Commands Summary (continued)
Command
n/a
:SBUS:UART:FRAMing
<value> (see
page 390)
Introduction to
The :SBUS subsystem commands control the serial decode bus viewing,
:SBUS
mode, and other options.
Commands
These commands are only valid on 4 (analog) channel oscilloscope models when a serial
N O T E
decode option has been licensed.
Reporting the Setup
Use :SBUS? to query setup information for the :SBUS subsystem.
Return Format
The following is a sample response from the :SBUS? query. In this case,
the query was issued following a *RST command.
:SBUS:DISP 0;MODE IIC
374
Query
:SBUS:UART:COUNt:TXFR
ames? (see page 389)
:SBUS:UART:FRAMing?
(see page 390)
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
Options and Query Returns
<frame_count> ::= integer in NR1
format
<value> ::= {OFF | <decimal> |
<nondecimal>}
<decimal> ::= 8-bit integer from
0-255 (0x00-0xff)
<nondecimal> ::= #Hnn where n ::=
{0,..,9 | A,..,F} for hexadecimal
<nondecimal> ::= #Bnn...n where n
::= {0 | 1} for binary