5
Commands by Subsystem
:TRIGger:UART:SOURce:RX
Command Syntax
:TRIGger:UART:SOURce:RX <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital0,..,DIGital15} for the MSO models
<n> ::= {1 | 2 | 3 | 4} for the four channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :TRIGger:UART:SOURce:RX command controls which signal is used as
the Rx source by the serial decoder and/or trigger when in UART mode.
Query Syntax
:TRIGger:UART:SOURce:RX?
The :TRIGger:UART:SOURce:RX? query returns the current source for the
UART Rx signal.
Return Format
<source><NL>
See Also
•
•
•
•
496
(see
page
658)
"Introduction to :TRIGger Commands"
":TRIGger:MODE"
on page 417
":TRIGger:UART:TYPE"
":TRIGger:UART:BITorder"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 411
on page 498
on page 489