Opee (Operation Status Enable Register) - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:OPEE (Operation Status Enable Register)

Command Syntax
:OPEE <mask>
<mask> ::= 16-bit integer
The :OPEE command sets a mask in the Operation Status Enable register.
Set any of the following bits to "1" to enable bit 7 in the Status Byte
Register and potentially cause an SRQ (Service Request interrupt to be
generated.
Table 40 Operation Status Enable Register (OPEE)
Bit
15-13
12
11
10
9
8-6
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 658)
Name Description
--- ---
HWE Hardware Event
OVLR Overload
--- ---
MTE Mask Test Event
--- ---
Commands by Subsystem
When Set (1 = High = True), Enables:
(Not used.)
Event when hardware event occurs.
Event when 50Ω input overload occurs.
(Not used.)
Event when mask test event occurs.
(Not used.)
5
145