Trigger:lin:signal:baudrate - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:TRIGger:LIN:SIGNal:BAUDrate

Command Syntax
:TRIGger:LIN:SIGNal:BAUDrate <baudrate>
<baudrate> ::= integer from 2400 to 625000 in 100 b/s increments
The :TRIGger:LIN:SIGNal:BAUDrate command sets the standard baud rate
of the LIN signal from 2400 b/s to 625 kb/s in 100 b/s increments. If you
enter a baud rate that is not divisible by 100 b/s, the baud rate is set to
the nearest baud rate divisible by 100 b/s.
Query Syntax
:TRIGger:LIN:SIGNal:BAUDrate?
The :TRIGger:LIN:SIGNal:BAUDrate? query returns the current LIN baud
rate setting.
Return Format
<baudrate><NL>
<baudrate> ::= integer from 2400 to 625000 in 100 b/s increments
See Also •
•
•
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 658)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 417
":TRIGger:LIN:TRIGger"
":TRIGger:LIN:SIGNal:DEFinition"
":TRIGger:LIN:SOURce"
on page 411
on page 469
on page 612
on page 466
Commands by Subsystem
5
465