Agilent Technologies InfiniiVision 5000 Series Programmer's Manual page 756

12
Programming Examples
756
*/
strResults = myScope.DoQueryString("*IDN?");
// Display results.
Console.Write("Result is: {0}", strResults);
/* AUTOSCALE - This command evaluates all the input signals
* and sets the correct conditions to display all of the
* active signals.
*/
myScope.DoCommand(":AUToscale");
/* CHANNEL_PROBE - Sets the probe attenuation factor for the
* selected channel.
* 0.1 to 1000.
*/
myScope.DoCommand(":CHANnel1:PROBe 10");
/* CHANNEL_RANGE - Sets the full scale vertical range in volts.
* The range value is eight times the volts per division.
*/
myScope.DoCommand(":CHANnel1:RANGe 8");
/* TIME_RANGE - Sets the full scale horizontal time in seconds.
* The range value is ten times the time per division.
*/
myScope.DoCommand(":TIMebase:RANGe 2e-3");
/* TIME_REFERENCE - Possible values are LEFT and CENTER:
* - LEFT sets the display reference one time division from
* the left.
* - CENTER sets the display reference to the center of the
* screen.
*/
myScope.DoCommand(":TIMebase:REFerence CENTer");
/* TRIGGER_SOURCE - Selects the channel that actually produces
* the TV trigger.
*/
myScope.DoCommand(":TRIGger:TV:SOURCe CHANnel1");
/* TRIGGER_MODE - Set the trigger mode to, EDGE, GLITch,
* PATTern, CAN, DURation, IIC, LIN, SEQuence, SPI, TV,
* UART, or USB.
*/
myScope.DoCommand(":TRIGger:MODE EDGE");
/* TRIGGER_EDGE_SLOPE - Set the slope of the edge for the
* trigger to either POSITIVE or NEGATIVE.
*/
myScope.DoCommand(":TRIGger:EDGE:SLOPe POSitive");
}
/*
* Extra()
* --------------------------------------------------------------
* The commands in this function are not executed and are shown
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
The probe attenuation factor may be from
Any channel can be selected.