Mtest:amask:create - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:MTESt:AMASk:CREate

Command Syntax
:MTESt:AMASk:CREate
The :MTESt:AMASk:CREate command automatically constructs a mask
around the current selected channel, using the tolerance parameters
defined by the :MTESt:AMASk:XDELta, :MTESt:AMASk:YDELta, and
:MTESt:AMASk:UNITs commands. The mask only encompasses the portion
of the waveform visible on the display, so you must ensure that the
waveform is acquired and displayed consistently to obtain repeatable
results.
The :MTESt:SOURce command selects the channel and should be set before
using this command.
See Also
•
•
•
•
•
•
Example Code •
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 658)
"Introduction to :MTESt Commands"
":MTESt:AMASk:XDELta"
":MTESt:AMASk:YDELta"
":MTESt:AMASk:UNITs"
":MTESt:AMASk:SOURce"
":MTESt:SOURce" on page 349
"Example Code" on page 320
on page 320
on page 326
on page 327
on page 325
on page 324
Commands by Subsystem
5
323