Trigger:uart:polarity - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

5
Commands by Subsystem

:TRIGger:UART:POLarity

Command Syntax
:TRIGger:UART:POLarity <polarity>
<polarity> ::= {HIGH | LOW}
The :TRIGger:UART:POLarity command selects the polarity as idle low or
idle high for the serial decoder and/or trigger when in UART mode.
Query Syntax
:TRIGger:UART:POLarity?
The :TRIGger:UART:POLarity? query returns the current UART polarity
setting.
Return Format
<polarity><NL>
<polarity> ::= {HIGH | LOW}
See Also
•
•
•
494
(see page 658)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 417
":TRIGger:UART:TYPE"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 411
on page 498