Trigger:uart:type - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

5
Commands by Subsystem

:TRIGger:UART:TYPE

Command Syntax
:TRIGger:UART:TYPE <value>
<value> ::= {RSTArt | RSTOp | RDATa | RD1 | RD0 | RDX | PARityerror
The :TRIGger:UART:TYPE command selects the UART trigger type.
When one of the RD or TD types is selected, the :TRIGger:UART:DATA and
:TRIGger:UART:QUALifier commands are used to specify the data value
and comparison operator.
The RD1, RD0, RDX, TD1, TD0, and TDX types (for triggering on data and
alert bit values) are only valid when a 9- bit width has been selected.
Query Syntax
:TRIGger:UART:TYPE?
The :TRIGger:UART:TYPE? query returns the current UART trigger data
value.
Return Format
<value><NL>
<value> ::= {RSTA | RSTO | RDAT | RD1 | RD0 | RDX | PAR | TSTA |
See Also
•
•
•
•
•
498
(see page 658)
| TSTArt | TSTOp | TDATa | TD1 | TD0 | TDX}
TSTO | TDAT | TD1 | TD0 | TDX}
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 417
":TRIGger:UART:DATA"
":TRIGger:UART:QUALifier"
":TRIGger:UART:WIDTh"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 411
on page 491
on page 495
on page 499