Agilent Technologies InfiniiVision 5000 Series Programmer's Manual page 721

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
* - VIEW turns on (starts displaying) an active channel or
* pixel memory.
* - BLANK turns off (stops displaying) a specified channel or
* pixel memory.
*/
oscp.DoCommand(":BLANk CHANnel1");
oscp.DoCommand(":VIEW CHANnel1");
/* TIME_MODE (not executed in this example) - Set the time base
* mode to MAIN, DELAYED, XY or ROLL.
*/
oscp.DoCommand(":TIMebase:MODE MAIN");
}
/*
* Capture()
* --------------------------------------------------------------
* This function prepares the scope for data acquisition and then
* uses the DIGITIZE MACRO to capture some data.
*/
private static void Capture()
{
/* AQUIRE_TYPE - Sets the acquisition mode.
* acquisition types NORMAL, PEAK, or AVERAGE.
*/
oscp.DoCommand(":ACQuire:TYPE NORMal");
/* AQUIRE_COMPLETE - Specifies the minimum completion criteria
* for an acquisition.
* of time buckets needed to be "full" before an acquisition is
* considered to be complete.
*/
oscp.DoCommand(":ACQuire:COMPlete 100");
/* DIGITIZE - Used to acquire the waveform data for transfer
* over the interface.
* acquisition to take place with the resulting data being
* placed in the buffer.
*/
/* NOTE! The use of the DIGITIZE command is highly recommended
* as it will ensure that sufficient data is available for
* measurement. Keep in mind when the oscilloscope is running,
* communication with the computer interrupts data acquisition.
* Setting up the oscilloscope over the bus causes the data
* buffers to be cleared and internal hardware to be
* reconfigured.
* If a measurement is immediately requested there may not have
* been enough time for the data acquisition process to collect
* data and the results may not be accurate.
* 9.9E+37 may be returned over the bus in this situation.
*/
oscp.DoCommand(":DIGitize CHANnel1");
}
/*
* Analyze()
The parameter determines the percentage
Sending this command causes an
Programming Examples
There are three
An error value of
721
12