Timebase:vernier - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

5
Commands by Subsystem

:TIMebase:VERNier

(see page 658)
Command Syntax
:TIMebase:VERNier <vernier value>
<vernier value> ::= {{1 | ON} | {0 | OFF}
The :TIMebase:VERNier command specifies whether the time base control's
vernier (fine horizontal adjustment) setting is ON (1) or OFF (0).
Query Syntax
:TIMebase:VERNier?
The :TIMebase:VERNier? query returns the current state of the time base
control's vernier setting.
Return Format
<vernier value><NL>
<vernier value> ::= {0 | 1}
See Also
• "Introduction to :TIMebase Commands" on page 400
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 407