Trigger:glitch:level - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

5
Commands by Subsystem

:TRIGger:GLITch:LEVel

Command Syntax
:TRIGger:GLITch:LEVel <level_argument>
<level_argument> ::= <level>[, <source>]
<level> ::= .75 x full-scale voltage from center screen in NR3 format
<level> ::= ±(external range setting) in NR3 format
<source> ::= {CHANnel<n> | EXTernal}
<n> ::= {1 | 2 | 3 | 4} for the four channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :TRIGger:GLITch:LEVel command sets the trigger level voltage for the
active pulse width trigger.
Query Syntax
:TRIGger:GLITch:LEVel?
The :TRIGger:GLITch:LEVel? query returns the trigger level of the current
pulse width trigger mode. If all channels are off, the query returns
"NONE."
Return Format
<level_argument><NL>
See Also •
•
•
•
448
(see page 658)
for internal triggers
for external triggers
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 417
":TRIGger:GLITch:SOURce"
":EXTernal:RANGe" on page 226
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 411
on page 452