Agilent Technologies InfiniiVision 5000 Series Programmer's Manual page 432

5
Commands by Subsystem
CAN Id specification is set by the :TRIGger:CAN:PATTern:ID
and:TRIGger:CAN:PATTern:ID:MODE commands.
CAN Data specification is set by the :TRIGger:CAN:PATTern:DATA
command.
CAN Data Length Code is set by the :TRIGger:CAN:PATTern:DATA:LENGth
command.
SOF is the only valid selection for analog oscilloscopes. If the automotive CAN and LIN
N O T E
serial decode option (Option AMS) has not been licensed, SOF is the only valid selection.
Query Syntax
:TRIGger:CAN:TRIGger?
The :TRIGger:CAN:TRIGger? query returns the current CAN trigger on
condition.
Return Format
<condition><NL>
<condition> ::= {SOF | DATA | ERR | IDD | IDE | IDR | ALL | OVER | ACK}
Errors •
See Also •
•
•
•
•
•
•
•
432
"- 241, Hardware missing"
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 417
":TRIGger:CAN:PATTern:DATA"
":TRIGger:CAN:PATTern:DATA:LENGth"
":TRIGger:CAN:PATTern:ID"
":TRIGger:CAN:PATTern:ID:MODE"
":TRIGger:CAN:SIGNal:DEFinition"
":TRIGger:CAN:SOURce"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 617
on page 411
on page 424
on page 425
on page 426
on page 427
on page 611
on page 430