Save:waveform[:Start] - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:SAVE:WAVeform[:STARt]

Command Syntax
:SAVE:WAVeform[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:WAVeform[:STARt] command saves oscilloscope waveform data
to a file.
If a file extension is provided as part of a specified <file_name>, and it does not match the
N O T E
extension expected by the format specified in :SAVE:WAVeform:FORMat, the format will be
changed if the extension is a valid waveform file extension.
See Also •
•
•
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 658)
"Introduction to :SAVE Commands"
":SAVE:WAVeform:FORMat"
":SAVE:WAVeform:LENGth"
":SAVE:FILename" on page 359
":RECall:SETup[:STARt]"
on page 358
on page 370
on page 371
on page 356
Commands by Subsystem
5
369