7
Obsolete and Discontinued Commands
:TRIGger:LIN:SIGNal:DEFinition
Command Syntax
:TRIGger:LIN:SIGNal:DEFinition <value>
<value> ::= {LIN | RX | TX}
The :TRIGger:LIN:SIGNal:DEFinition command sets the LIN signal type.
These signals can be set to:
Dominant low signals:
• LIN — the actual LIN single- end bus signal line.
• RX — the Receive signal from the LIN bus transceiver.
• TX — the Transmit signal to the LIN bus transceiver.
With InfiniiVision 5000 Series oscilloscope software version 5.00 or greater, this command
N O T E
is available, but the only legal value is LIN.
Query Syntax
:TRIGger:LIN:SIGNal:DEFinition?
The :TRIGger:LIN:SIGNal:DEFinition? query returns the current LIN signal
type.
Return Format
<value><NL>
<value> ::= LIN
See Also
•
•
•
•
612
(see
page
658)
"Introduction to :TRIGger Commands"
":TRIGger:MODE"
on page 417
":TRIGger:LIN:SIGNal:BAUDrate"
":TRIGger:LIN:SOURce"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 411
on page 465
on page 466