Sbus:display - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

5
Commands by Subsystem

:SBUS:DISPlay

Command Syntax
:SBUS:DISPlay <display>
<display> ::= {{1 | ON} | {0 | OFF}}
The :SBUS:DISPlay command turns displaying of the serial decode bus on
or off.
This command is only valid on 4 (analog) channel oscilloscope models when a serial decode
N O T E
option has been licensed.
Query Syntax
:SBUS:DISPlay?
The :SBUS:DISPlay? query returns the current display setting of the serial
decode bus.
Return Format
<display><NL>
<display> ::= {0 | 1}
Errors
•
See Also •
•
•
•
•
380
(see page 658)
"- 241, Hardware missing"
"Introduction to :SBUS Commands"
":CHANnel<n>:DISPlay"
":VIEW" on page 162
":BLANk" on page 130
":STATus" on page 159
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 617
on page 374
on page 194