:CDISplay
Command Syntax
:CDISplay
The :CDISplay command clears the display and resets all associated
measurements. If the oscilloscope is stopped, all currently displayed data
is erased. If the oscilloscope is running, all the data in active channels and
functions is erased; however, new data is displayed on the next
acquisition.
See Also
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see
page
658)
"Introduction to Root (:) Commands"
":DISPlay:CLEar"
on page 210
Commands by Subsystem
on page 124
5
131