Save:waveform[:Start] - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:SAVE:WAVeform[:STARt]

Command Syntax
:SAVE:WAVeform[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:WAVeform[:STARt] command saves oscilloscope waveform data
to a file.
If a file extension is provided as part of a specified <file_name>, it must match the
N O T E
extension expected by the format specified in :SAVE:WAVeform:FORMat.
See Also •
•
•
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 586)
"Introduction to :SAVE Commands"
":SAVE:WAVeform:FORMat"
":SAVE:WAVeform:LENGth"
":SAVE:FILename" on page 304
":RECall:SETup[:STARt]"
on page 303
on page 314
on page 315
on page 301
Commands by Subsystem
5
313