Marker:x1Position - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual

19
:MARKer Commands

:MARKer:X1Position

Command Syntax
:MARKer:X1Position <position> [suffix]
<position> ::= X1 cursor position in NR3 format
<suffix> ::= {s | ms | us | ns | ps | Hz | kHz | MHz}
The :MARKer:X1Position command:
• Sets :MARKer:MODE to MANual if it is not currently set to WAVeform
• Sets the X1 cursor position to the specified value.
X cursor units are set by the :MARKer:XUNits command.
Query Syntax
:MARKer:X1Position?
The :MARKer:X1Position? query returns the current X1 cursor position.
This is functionally equivalent to the obsolete :MEASure:TSTArt
command/query.
If the front-panel cursors are off, the marker position values are not defined and an error is
N O T E
generated. Make sure to set :MARKer:MODE to MANual or WAVeform to put the cursors in
the front-panel Normal mode.
Return Format
<position><NL>
<position> ::= X1 cursor position in NR3 format
See Also •
•
•
•
•
•
•
320
(see page 790)
(see ":MARKer:MODE"
"Introduction to :MARKer Commands"
":MARKer:MODE" on page 319
":MARKer:X2Position"
":MARKer:X1Y1source"
":MARKer:X2Y2source"
":MARKer:XUNits" on page 325
":MEASure:TSTArt" on page 729
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
on page 319).
on page 318
on page 322
on page 321
on page 323