Configuration Via Console-Based-Management-Tool (Cbm) Using A Terminal Program; Figure 50: Cbm Main Menu (Example) - WAGO I/O System 750 Manual

WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR
8.8.2 Configuration via Console-Based-Management-Tool (CBM)
using a Terminal Program
The Console-Based Management Tool (CBM) is basically used for the initial
configuration and startup of the controller via a terminal program.
Therefore, it only provides a subset of the controller parameters. For example,
parameters that cannot be displayed in a terminal window in a reasonable way
and are not necessary for initial startup are not displayed.
1. Connect a PC to the ETHERNET interface X1 of the controller using an
SSH terminal program.
2. Start the terminal program.
Select "SSH" as the connection type, and enter the IP address of the
3.
controller and port 22 as the connection parameters.
4. Log in to the Linux
The user name and the password are provided in the Section "Users and
Passwords" > "Linux
Start the configuration tool by entering the command "cbm" (case sensitive)
5.
on the command line and then press [Enter].

Figure 50: CBM main menu (example)

system as a "super user."
®
User Group."
®
Version 1.7.0, valid from FW Version 04.01.10(23)
Commissioning 127
Manual