Table of Contents
Advertisement
| Spanning Tree Algorithm
C
8
HAPTER
Displaying Interface Settings for STA
D
I
ISPLAYING
NTERFACE
Figure 116: Configuring Interface Settings for STA
S
STA
ETTINGS FOR
Use the Spanning Tree > STA (Configure Interface - Show Information)
page to display the current status of ports or trunks in the Spanning Tree.
CLI R
EFERENCES
"show spanning-tree" on page 1302
◆
P
ARAMETERS
These parameters are displayed:
Spanning Tree – Shows if STA has been enabled on this interface.
◆
◆
BPDU Flooding – Shows if BPDUs will be flooded to other ports when
spanning tree is disabled globally on the switch or disabled on a specific
port.
STA Status – Displays current state of this port within the Spanning
◆
Tree:
Discarding - Port receives STA configuration messages, but does
■
not forward packets.
Learning - Port has transmitted configuration messages for an
■
interval set by the Forward Delay parameter without receiving
contradictory information. Port address table is cleared, and the
port begins learning addresses.
Forwarding - Port forwards packets, and continues learning
■
addresses.
– 286 –
Advertisement
Chapters
Table of Contents
