End-Of-Life Ap Model Detected; Vlan Configuration Mismatch On Non Dhcp/Nat Wlan - Ruckus Wireless Virtual SmartZone High Scale Reference Manual

Alarm Types
Configuration Alarms
TABLE 64 AP configuration generation failed alarm (continued)
Alarm
Displayed on the web
interface
Description
Recommended Actions

End-of-life AP model detected

TABLE 65 End-of-life AP model detected alarm
Alarm
Alarm Type
Alarm Code
Severity
Aggregation Policy
Attribute
Displayed on the web
interface
Description
Recommended Actions
NOTE
Refer to Configuration Events

VLAN configuration mismatch on non DHCP/NAT WLAN

TABLE 66 VLAN configuration mismatch on non DHCP/NAT WLAN alarm
Alarm
Alarm Type
Alarm Code
Severity
Aggregation Policy
Attribute
Displayed on the web
interface
88
AP configuration generation failed
Failed to generate configuration for [{apCfgGenFailedCount}] AP(s) under
zone[{zoneName}]
This alarm is triggered when the controller fails to generate the AP configuration
under a particular zone.
APs under these zone stay functional but are unable to receive the new settings.
Contact Ruckus support to file an error bug along with the log file.
End-of-life AP model detected
cfgGenSkippedDueToEolAp
1023
Major
From the event code 1023 an alarm is raised for every event. A single event
triggers a single alarm.
"nodeMac"="50:A7:33:24:E7:90","zoneName"="openZone","model"="R300,T30
0"
Detected usage of end-of-life ap model(s)[{model}] while generating configuration
for AP(s) under zone[{zoneName}]
This alarm is triggered when the controller detects the AP model's end-of-life
under a certain zone.
These obsoleted APs occupies licensed AP space. Disconnect these
unsupported AP models from the given zone by:
• Reset the APs to a factory setting using the AP command line
• Delete these APs through the controller Web Interface > Configuration
AP List
on page 240.
VLAN configuration mismatch detected between configured and resolved VLAN
with DVLAN/VLAN pooling configuration on non-DHCP/NAT WLAN
apCfgNonDhcpNatWlanVlanConfigMismatch
1024
Critical
From the event code 1023 an alarm is raised for every event. A single event
triggers a single alarm.
"ssid"="xxxx", "wlanID"="xxxx", "configuredVlan"="5"
DHCP/NAT gateway AP [{apMac}] detected VLAN configuration mismatch on
non-DHCP/NAT WLAN [{ssid}]. Configured VLAN is [{configuredVlan}] and
resolved VLAN is [{vlanId}]. Clients may not be able to get IP or access Internet.
Ruckus SmartCell Gateway 200 Virtual SmartZone High Scale and SmartZone 300 Alarm and Event Reference Guide
Part Number: 800-71565-001 Rev A