Ipmidrvstatus; Licensing Alarms - Ruckus Wireless Virtual SmartZone High Scale Reference Manual

Alarm Types

Licensing Alarms

TABLE 116 ipmiPsStatus alarm (continued)
Alarm
Attribute
Displayed on the web
interface
Description
Recommended Actions

ipmiDrvStatus

TABLE 117 ipmiDrvStatus alarm
Alarm
Alarm Type
Alarm Code
Severity
Aggregation Policy
Auto Clearance
Attribute
Displayed on the web
interface
Description
Recommended Actions
NOTE
Refer to IPMI Events

Licensing Alarms

NOTE
Alarms 1242 and 1243 are not applicable for vSZ-H.
Following are the alarms related to licensing.
• TTG session critical threshold
• TTG session license exhausted
• License going to expire
• Insufficient license capacity
114
ipmiPsStatus
"id"="x", "status"="xxxxx", "nodeMac"="xx:xx:xx:xx:xx:xx"
Power supply [{id}] [{status}] on control plane [{nodeMac}]
This alarm is triggered when the control plane's power supply status is shown as
a low/high input.
Check the power supply cord. If the problem persists, replace the power supply
cord.
ipmiDrvStatus
ipmiDrvStatus
914
Major
From the event code 914 an alarm is raised for every event. A single event
triggers a single alarm.
The alarm code is auto cleared with the event code 939.
"id"="x", "status"="xxxxx", "nodeMac"="xx:xx:xx:xx:xx:xx"
Disk drive [{id}] [{status}] on control plane [{nodeMac}]
This alarm is triggered when the control plane's disk drive status is shown as
either not working or corrupted.
The operator / user needs to replace the hard disk drive.
on page 277.
on page 115
on page 115
on page 115
on page 116
Ruckus SmartCell Gateway 200 Virtual SmartZone High Scale and SmartZone 300 Alarm and Event Reference Guide
Part Number: 800-71565-001 Rev A