Insufficient License Capacity; Pmipv6 Alarms; Config Update Failed - Ruckus Wireless Virtual SmartZone High Scale Reference Manual

Alarm Types

PMIPv6 Alarms

TABLE 120 License going to expire alarm (continued)
Alarm
Description
Recommended Actions

Insufficient license capacity

TABLE 121 Insufficient license capacity alarm
Alarm
Alarm Type
Alarm Code
Severity
Aggregation Policy
Attribute
Displayed on the web
interface
Description
Recommended Actions
NOTE
Refer to Licensing Interface Events

PMIPv6 Alarms

NOTE
This section is not applicable for vSZ-H.
Following are the alarms related to PMIPv6.
•

Config update failed

• LMA ICMP unreachable
• LMA failed over on page 117
• DHCP connection lost
Config update failed
TABLE 122 Config update failed alarm
Alarm
Alarm Type
Alarm Code
Severity
116
License going to expire
This alarm is triggered when the validity of the license is going to expire.
Check the validity of licenses. You would need to purchase additional licenses if
validity expires.
Insufficient license capacity
apConnectionTerminatedDueToInsufficientLicense
1256
Major
From the event code 1256 an alarm is raised for every event. A single event
triggers a single alarm.
"licenseType"=" xxx"
Insufficient [{licenseType}] license is detected and it will cause existing AP
connections to terminate.
This alarm is triggered when connected APs are rejected due to insufficient
licenses.
Check the number of licenses. You would need to purchase additional licenses
due to insufficient number of licenses.
on page 286.
on page 116
on page 117
on page 118
Config update failed
updateCfgFailed
5004
Major
Ruckus SmartCell Gateway 200 Virtual SmartZone High Scale and SmartZone 300 Alarm and Event Reference Guide
Part Number: 800-71565-001 Rev A