Ap Ip Address Updated; Ap Reset To Factory Default; Ap Channel Updated - Ruckus Wireless Virtual SmartZone High Scale Reference Manual

Events Types
AP State Change Events
TABLE 257 AP disconnected event (continued)
Event
Displayed on the web
interface
Description
Auto Clearance

AP IP address updated

TABLE 258 AP IP address updated event
Event
Event Type
Event Code
Severity
Attribute
Displayed on the web
interface
Description

AP reset to factory default

TABLE 259 AP reset to factory default event
Event
Event Type
Event Code
Severity
Attribute
Displayed on the web
interface
Description

AP channel updated

TABLE 260 AP channel updated event
Event
Event Type
Event Code
Severity
Attribute
Displayed on the web
interface
Description
174
AP disconnected
AP [{apName&&apMac}] disconnected
This event occurs when the AP disconnects from the controller.
This event triggers the alarm 303, which is auto cleared by the event code 312.
AP IP address updated
apIPChanged
304
Informational
"apMac"="xx:xx:xx:xx:xx:xx"
AP [{apName&&apMac}] reset because of an IP address change
This event occurs when the AP is reset due to a change in the IP address.
AP reset to factory default
apFactoryReset
305
Informational
"apMac"="xx:xx:xx:xx:xx:xx"
AP [{apName&&apMac}] reset to factory default settings
This event occurs when the AP is reset to factory default settings.
AP channel updated
apChannelChanged
306
Informational
"apMac"="xx:xx:xx:xx:xx:xx", "radio"="xxx", "fromChannel"="xx",
"toChannel"="xx"
AP [{apName&&apMac}] detected interference on radio [{radio}] and has switched
from channel [{fromChannel}] to channel [{toChannel}]
This event occurs when the AP detects the radio interference and switches to
another channel.
Ruckus SmartCell Gateway 200 Virtual SmartZone High Scale and SmartZone 300 Alarm and Event Reference Guide
Part Number: 800-71565-001 Rev A